Home      About Perflex      Contact us      Products Catalog      Certificates      Articles      Events      Videos
  • German
  • Перфлекс Рус
  • English
for Patients     |     for Dentists     |     for Labs     |     for Distributors

Home > for labs
for labs
STARTER KIT
SMART 101
Instructions for Hydraulic Presses
Polishing kit - General Instructions
Duplicating Mixing matrix
ISOSEP FILM Instructions
ISOSEP OIL SEPARATOR instructions
FLEXI CLEAN
Manual for processing T-Crystal
Manual for processing Flexi Nylon
Manual for processing Acry Free
Manual for processing Acetal
Manual for processing Biosens
ISOSEP OIL SEPARATOR instructions

ISOSEP OIL SEPARATOR -   T-CRYSTAL

 

ISOSEP  OIL Extra thin separator for injection molding, is specially formulated for Perflex T-crystal Thermoplastic material allow a smooth and clean appliance after injection.

Suitable to be used also to apply a very thin coat with a soft brush as a finish outlook  glaze after finish and polish.

 

Instructions:

When using as separator for Perflex T-CRYSTAL injection:

Take the 2 flask halves from boiling water 8 min before injection dry out  remaining water with compressed air , apply 2 thin coats over mold surfaces using a soft brush, let a minute to dry and apply immediately   one  thin coat of ISOSEP - OIL with a soft small brush over mold surfaces only. Close flask to inject (4 screws) and place into injector 3 min. before injection or when alarm sound to inject on SMART 101 super injector.

CAUTION: Thick areas of ISOSEP OIL separator may cause separation of injected areas. Be sure to apply very thin coats.

WARNING: Please wear heat resistant protective gloves during process.

When using as a finish glaze outlook for all thermoplastics and conventional acrylic materials.

After a perfect finish and polish shine is achieved, clean for 15min under ultrasonic cleaning and disinfecting from remaining polishing materials. Dry the appliance with compressed air and apply a thin coat with a small soft brush inside and outside of the appliance.

Caution: not to be applied in areas where are treated for an acrylic rebase as in immediate dentures and overdentures on implants.

Protect from sun, storage in a cool dark and dry place.

All rights reserved to Perflex ltd.

Perflex ltd  www.perflexltd.com                             conteins: 150ml

CE                                                                      Catalog No: 55503



PDF