Home      About Perflex      Contact us      Products Catalog      Certificates      Articles      Events      Videos
  • German
  • Перфлекс Рус
  • English
for Patients     |     for Dentists     |     for Labs     |     for Distributors

Home > products catalog | isosep oil separator
Products Catalog
ISOSEP OIL SEPARATOR
(cat. no. 55503)

ISOSEP OIL SEPARATOR AND ISOLATING MEDIA FOR T-CRYSTAL  - second  coat step

 

INSTRUCTIONS: When using as separator for perflex T-crystal and Biosens 
injection: Place the 2 halves flask in a bath of boiling water.
Remove the flask from boiling water 8 min before injection.
Dry out remaining water with compressed air, apply 2 thin coats of ISOSEP FILM as first step,
over mold surfaces ONLY using a soft brush,leave a minute to dry and apply immediately a thin coat of ISISEP OIL close flask to inject and place into injector 2 min before injection or when alarm sound to inject whit SMART 101/101-400 super injector.
WHEN USING AS FINISH GLAZE OUTLOOK: after a perfect finish and polish shine is achieved,
clean for 15min under ultrasonic
cleaning and disinfecting from remaining polishing agents.
Dry the appliance with compressed air and apply a thin coat with a small soft brush inside and outside of the appliance.
not to ba applied in areas treated for an acrylic rebase as immediate dentures and over-dentures on implants
CAUTION: Avoid coating with Isosep Film acrylic replacement teeth, if this occurs, scrape separator for off from surfaces of the teeth. 
Thick or wet areas of separator may cause separation of injected areas.
Isosep oil will not cause any damage if touching surfaces of acrylic teeth prior to injection.
be sure to apply very thin coats.
Please wear heat resistant protective gloves during process.

 

Cat. no. 55503 1 aluminum bottle airless (not gas container)

150 ml net weight.




Instructions